STORM RDX QUIVER ASSEMBLY
3
Attach quick detach (male) attachment.
4
Remove sling stud and
3
⁄
8
''
barrel screw.
5
Place the quiver bracket assembly over
the two barrel holes and insert ¾'' screws.
6
Install the quick disconnect
(female) attachment.
7
Insert the 3-Arrow Instant Detach Quiver
into the female bracket and lock into place
with the lever.
2
Attach rubber hose to quiver cup.
1
3-Arrow Instant Detach Quiver
Mounting Kit
2
1. The 3-Arrow Instant Detach Quiver Kit contains
the following parts (photo 1):
• ONE (1) Quiver
• ONE (1) Quick disconnect (male) attachment
• TWO (2) ¾'' oval counter-sink Phillips screws
• ONE (1) Rubber hose (quiver hanger)
• TWO (2) Hose plugs
• ONE (1) Quick disconnect (female) attachment
with lever
• TWO (2) Phillips pan-head machine screws
• ONE (1) Quiver mounting bracket with sling stud
• TWO (2)
7
⁄
16
'' Nylock nuts
• TWO (2) ¼ - 20 x ¾'' Pan-head screws
2. Attach the rubber hose to the quiver cup. First, from the bottom of the quiver’s cup,
insert both ends of the rubber hose approximately two-inches into each hole and
insert a hose plug into each end. Then, pull the hose back toward the bottom of the
quiver cup and seat the hose plugged ends into the counter-sunk holes (photo 2).
Note: Once inserted, the hose plugs cannot be removed.
3. Position the quick disconnect (male) attachment to the backside of the quiver post,
over the holes closest to the quiver cup. Insert the ¾'' oval counter-sink Phillips
screws and tighten (photo 3).
4. Remove the front sling stud and the ¼ - 20 x
3
⁄
8
'' button-head screw directly below
it, from the bottom of the barrel (photo 4). Note: Use a
5
⁄
32
'' Allen wrench to
remove the barrel screw.
5. Place the quiver’s mounting bracket over the two holes you just removed the sling
stud and pan-head screw from. Align the mounting bracket either facing the left or
right side of the crossbow, based on personal preference.
Insert and tighten the two ¼ - 20 x ¾'' Pan-head screws into the same holes you
removed the sling stud and barrel screw from (photo 5). Use a
5
⁄
32
'' Allen wrench
to tighten.
6. Install the quick disconnect (female) attachment with lever on the quiver mounting
bracket using the two Phillips pan-head machine screws and the
7
⁄
16
'' Nylock
nuts. Align the open end with the lever facing the front of the crossbow (photo 6).
7. Insert the quiver with male attachment into the quick disconnect (female) attachment
with lever, and lock into place (photo 7).
(4 pages)
(4 pages)
Manymanuals.com
Manymanuals.de
Manymanuals.fr
Manymanuals.it
Manymanuals.pl
Manymanuals.cz
Manymanuals.es
Manymanuals-pt.com
Comments to this Manuals